Everflow PCGL1148-5 Steel, Pre Cut Industrial Pipe Schedule 40 Threaded Fitting, 1/2" x 48", Galvanized (Pack of 5)

Threads on 2 pipes looked at so far had slight damage, essentially cosmetic as couplings still worked. Used blue driving head on one of the pipes -- it stripped the thread after some hammering. Tip: need retighten head every few blows as the hammering loosen the driving head (and other pipes below). bought a 12-inch pipe from a hardware store to use as a sacrificial pipe. The threads on that stripped a bit also, even though tried to keep tight (sledge hammer not always hitting center part of issue). Can't really speak to pipe quality, as have not tried other brands for comparison.

Chose these pipes from the parts list on a YouTubers video about sand point wells. Not sure if they received better quality ones but the threads immediately rolled over like butter and I could not secure pipes together or keep them straight because of this. Returning them as they are not intended to be used this way as advertised

Awesome. Every where else 56 dollars a piece. Thank you

The threads are very soft and damage easily, esp. since they didn't mesh quite right with any of several brands of NPT couplings. These may be fine for furniture, but not for driving a sandpoint well, and I'm not confident about other plumbing tasks; with what I estimated to be less than 1/2" of good mating, there was more "interference" than "fit" in those joints!

These pipes were complete junk when you put them together and hammer them into the ground the threads just fall apart very cheap and weak steel .