Universal 2-4 AWG 175A Battery Connect Quick Connector Plug for 12V Winch Trailer Driver Electrical Devices

I used this connector with 4 AWG wire to connect a winch on my car trailer to run off of my truck's battery. You may need a special crimping tool to crimp the lugs it comes with but my brother is an electrician so I'm lucky that I could just borrow one. It's a nice sturdy high quality connector that works great. If I get a new truck I won't hesitate to buy it again.

I purchased three sets of these for several projects. I used one set to replace a worn out set installed on my truck for my 8000 pound Warn winch. They are a direct replacement for the original Warn plugs that came with the winch. I used a second set to install a outlet at the rear of my truck using welding cable. The third set was installed on my utility trailer for a 2000 pound winch and to modify a set of jumper cables. The lugs were easy to install utilizing solder plugs and are shipped with nice rubber covers. They appear to equal to and are rated for the same amp draw as the Warn connectors.

The good news is that this is a very nice plug pair with massive contact surfaces and really nice weather boots. The bad news is that if you are trying to use this with 4 gauge wire, like I was, there is a lot of gap. I don't think that crimping or soldering will work well unless you fit a spacer to take up the extra room. So this is really not a 4 AWG connector.

works great and was just what I was looking for. I installed it in my car as a quick disconnect for my power inverter. that way when i wasnt using the inverter I could just unplug and take it out. i put a bigger power inverter in my car. 800w. so i have to wire it straight to the battery. i like these even better because when i disconnect it i can then use the cap and cover the end that is still in the car. that way no little curious fingers, forks, or over objects find there way in the end from my little 3 year old. it was a fairly easy install and even easier to use. i soldiered my wires in as i did not have a crimper tool.

I used these to connect my Warn winch to my truck. I mounted a portable winch in the bed of my truck and wanted heavy cables that could be disconnected easily and allow me to remove the winch when not needed These plugs are what you need. They are well built and easy to connect to your cables...sort of. I used 2 ga copper strand jumper cables which were just a little large for the metal part that slides into the plastic connector. After a few strands were removed, the cables were soldered and everything went together easily. These plugs are very convenient with high amp rating. Check the amp rating on the plugs to be sure they can handle the load and match the wires.

Nice product. The quality is very robust. I hate thieves so I wanted a way to disconnect my portable winch quickly for safe storing. This allows me to not only do it in seconds but the ability to move my winch to other vehicles via 2" receiver and jumper cables with a matching connector. I searched my local NAPA, Auto Zone, Marine stores, electrical stores and box stores for this item. One store had them and for the same kit I got here for less than $20 they wanted $59. Save your time just buy it.

These are fantastic. Used to create 1/0 jumper cables and a quick disconnect winch lead. It will not fit 1/0 and requires alot of trimming with the supplied lugs. Other than that theyre great and i now have bought over 5 sets!

I got these for the winch cables on my JEEP. Now if I need to use it, I just open the hood and couple them up and away we go. No more wondering if I bumped the switch and drained the battery, because it was constantly tide straight to the terminals. It takes some doing to install these as I have them, but well worth it.