Danby DKC054A1BSLDB 5.4 Cu.Ft. Kegerator, Auto Defrost and Mechanical Thermostat, Keg Cooler with Scratch-Resistant Worktop and Reversible Door Hinge, Single Tap, Steel

I was replacing an older Danby unit so needed one with the same hole measurement as the tower is mounted to the counter top.The dimensions listed and in some of the comments are not quite right. I did receive confirmation from Danby on the hole placement within a day of sending an email to their support site.I ordered the unit from VM Express. It came a day ahead of time. It is shipped in the original Danby box and arrived without any damage. All components were securely packed and wrapped within the unit. I did notice when fedex delivered, it was on its side so it is important to leave upright for 12 or more hours before you plug it in to allow the compressor fluid to resettle.I upgraded to a double tower in the picture as I had spare parts from the previous model. Also added active cooling fan to the back since there is now a metal grid protecting the compressor.All in all all seems good. The only small thing is there is no internal tower cooling fan but can be added. Also the beer hose connector to the tower supplied is factory sealed so if you need to replace the connector -you have to cut that off. Would rather have the hose and barb connectors to allow more flexibility. I also purchased some fridge thermometers to place inside the unit to help get the temperature setting correct.I am happy with my purchase.

The kegerator is working flawlessly. It is an economical choice over buying bottles or cans and having to recycle or otherwise dispose of the containers.Continues to work well on a daily basis!

Literature does not match product. Vague diagram.

I have this with two 1/6 barrel kegs in it. It will only cool them down to 41 degrees Fahrenheit. This is great for a cool beer, but not a cold beer. I wouldn't buy this again.

Looks good, works as expected, and easy to setup. Already gone through a keg with it and no issues. If you didn't know, most good auto parts stores, like Napa, will swap CO2 bottles so you don't have to go to some beer place for it or directly to a compressed gas specialty shop. When you set the CO2 keg pressure, remember to draw a couple of glasses of beer and then adjust again to make sure you got it. Super easy to adjust, but you have to make sure it's good after a few as it's not a one and done thing.Bottoms Up!

You'll need to know at least slightly what you're doing. This unit needs assembly on arrival (just the tap system part). It's not difficult, but setting up hose systems is a bit of a pain. Also, mine was short the screws for the top rail... It's not critical, but I would have liked to use them. Besides that? It holds temp and dispenses like a champ!

I was so disappointed with this purchase. I bought this as a birthday gift for my fiancé. Unfortunately, it came with tons of as you can see in the pictures. This is not an acceptable birthday gift by any means!!!!!!!

CyberSavings did a great job with getting this product to us. It was lost in the first shipment and they sent a replacement right away. It was easy to assemble and works great. The customer service of the seller was top notch.

Hubby and friends love this ! Great price, works well. Easy to set up.

Arrived with a dent on the front bottom of door. But works good. Beer is cold, and dispenses perfect

The double tap wasn’t available and the single tap replacement cooler came with a C02 bottle from China that didn’t meet CSA specs.

Great home keg cooler. Works like it should, takes a little time to set it up to prevent too much foam in beer. Needed to get another CO2 tank, local suppliers would not fill due to pressure release value having to high of a rating. Other than that I love it. Highly recommended.

I do not recommend buying this. There were missing parts( washers, the tap handle, screws for the railing on top. Issues with keeping a consistent temp. No value in using it as a kegerwtor so it's now an expensive bar fridge.