B&W Trailer Hitches Turnoverball Gooseneck Hitch - GNRK1111 - Compatible with 2011-2016 Ford F250 & F350 Trucks

Could not be happier! American made, precision fitment on my 2016 F350. There is a youtube video from B&W that helps with the install - search for "B&W turnover ball 1111". The paper instructions are OK, but the video is well made and a big help. The instructions don't require that you remove the rear wheels, but it helps when it comes time to torque the bolts. I have a set of Husky wheel well liners. If you have these, you'll want to remove them first. In order to re-install them you'll need to shorten the latch pin handle about 3-4 inches. Then, when you reinstall the Husky liners the turnover ball framework is completely hidden. You'll just have to reach behind the driver's side liner to operate the latch pin. I'm happy with this product.

Only complaint was the fact that I had to cut a notch in the bed seam, and temporarily remove the tail pipe to install. But I typically pull 10-15k and it’s holding up super well

It fit well and works great. 2 nd one I’ve purchased

This is the second b&w hitch I've had I don't like the factory puck and with the b&w you can get the extended height ball to keep the trailer hitch from touching the bed floor when you get the trailer cocked in unusual positions.

great hitch easy to install took me about 2 hrs to install it

Was fairly easy to install. It would be easier if you have a lift. I didn’t remove my wheels like a YouTube video shows. The best way to install the center piece where the ball goes, after installing the 2 cross pieces take ratchet strap and hook on the bar inside the hole where the ball fits and lay a 2x4 across the bed and hook the ratchet strap to the board and pull the center part up into the hole in the bed until it bottoms out. It makes it easier when you’re trying to put the bolts into the cross pieces.

Awesome company! They had a problem with delivery and got it send out of another warehouse before i even missed a beat. It is crazy how on top of things they are. I haven't installed it yet but it is the same that came off my truck. So i anticipate no problems.

This was a bear to install. Watch the video on the B&W site, that's helps a lot. If installing on a new truck, probably would not be too bad, but on a used truck where the bed has been used makes the spacing between the frame and bed floor really tight. Torquing everything was a bit of a challenge as well, but take your time, it's not rocket science just tedious. Overall, B&W makes a quality product that I've used for years on trucks, but this is my 1st install.

Excellent fit. Self install