40pcs Round Heavy Duty Nail-on Felt Pad for Furniture Chair Table Leg Feet Floor Protectors Slide Smoothly (Black, Pad Diameter 28mm)

Very useful

Worked great.

Just installed them and they seem to durable and easy to install. Recommend pre-drilling before hammering nail in.

Why didn’t I use these earlier??? I have been dealing with stick ones that fall off for years. These should be much better. I followed the advice of many reviewers and drilled a slightly smaller hole into the base of my chairs so that I could hammer in the pads without bending the screws. Didn’t bend a single one!

I bought these for my kitchen table and chairs, which were screeching horrifically against our tile floors. I like they are hammered into the bottom of the chair and table legs to ensure they won't just end up sliding off. It has been about 1 month since we put them on and zero problems and they're still intact firmly.

Easy to install, you do need to use a Hammer. Ours have lasted on for 14 months even thoug we use our chairs every single day. And it looks like they will last a lot more time. These are the best ones out of many we tried before. They don't schratch our hardwood floors and they don't leave any mark. They are not bulky and our chairs look nice.We liked them so much that we purchased another set for a friends table. Once our wear out we will be buying these again.

I am glad I measured my chair legs before ordering these because they fit perfectly. The felt ends feel durable and will do a lot better job protecting my hard floors than the previously existing plastic feet. I just popped the old feet off with a small pry bar. Then I used the old feet to hammer in a pilot hole of sorts. If I wasn't in the middle of unpacking from a move, I would have probably grabbed my drill to make a pilot hole for these feet because the nails aren't super thick and will bend if driven directly into fresh hardwood. No complaints though because the price is right and they seem to be doing their job perfectly.

Nails are very soft and I've bent about 25% of them nailing them into the chair leg. One had the nail head showing through the felt, so inspect them before putting onto your furniture. (Buy more than you need because of how much they bend!) The felt sometimes isn't even and can be higher on one side than another and it can become uneven from hammering it in. All in all, you get what you pay for!

average quality, not the best...the felt on some of the pieces tends to separate from the plastic, so the glue is not the best quality. however, i have been able to protect all of my furniture with them.

Exactly as advertised.

On time arrival. item as described. A+++

Awesome

these were a lot smaller than i thought and does not suit dining chairs that have a med to large footprint. a few of the nails were faulty / mal aligned and were disposed.