Avery SW900-190-O GLOSS BLACK 5ft x 5ft (25 Sq/ft) Supreme Vinyl Car Wrap Film

I did a LOT of research. I needed a non-metallic gloss black. This vinyl rose to the top as the easiest for a beginner to install, so this was a match. You can find this vinyl cheaper elsewhere but i needed the tools so bought it all here.Good... It's very thin and flexible so it's easier to install. With the help of a friend i successfully wrapped my hood and it looks great.Bad... Because it's very thin and flexible, it also shows EVERY imperfection underneath. So you really have to prepare well. If necessary, sand gently, fill fully. Installers also said that it's less durable and more susceptible to gravel chips then the heavier products.In my case, i had an old car with a hood that had been damaged by a high pressure car wash. So even with a couple tiny imperfections, it was great and my sweet old ride is back.

Product sticks way too much, it was sticking too much even coming off the roll, could not readjust without putting too much pressure on the wrap

The media could not be loaded. I wrapped the roof of my car with this vinyl and it was perfect! It was my first time working with vinyl so I made some mistakes with the shark fin antenna but it was super easy to work with and looks great!! Well worth it.

Beautiful as-paint quality. Heats and stretches nicely. No complaints at all.

Tore within minutes of putting it on and it did not allow to stretch on top of the roof of the vehicle

This was the first time ever vinyl wrapping a latge surface(roof of my coupe). This is very forgiving and takes to heat very well, but do not over heat! That being said, i was this came with a protective film, as the streaking left from my felt-tipped squeegie can be seen at certain angles. All in all a great vinyl, i will update in a few months to see how this hold up!

I went this route for my roof instead of getting it repainted, and am pretty happy with the result. I learned a lot as this was the first wrap I've ever applied - there were some mistakes (my fault) but I would definitely use Avery again.Be careful when cleaning it - microfibers and detail spray can cause small microscratches. I would be sure to only use automotive soap and water and dry lightly with a microfiber drying towel.

Order was late due to Covid-19, contacted seller and the informed me it was still on it's way shortly after I emailed them. Literally showed up a few hours later. Application was tough, definitely due to my inexperience go applying vinyl wraps. But even with a few hiccups it still came out pretty great. Quality of the wrap was perfect. Absolutely no defects.