Aluminum L Bracket Vertical Horizontal Switching Quick Release Plate for DJI Ronin RS2 RSC2 Zhiyun Weebill-S Gimbal Stabilizer Tripod Monopod and SLRs

It is in fact NOT easy switching between the two orientations. If you want to film both vertically and horizontally in one session, this product is not right for you. The product is designed to replace the gimbal's entire base plate (I have Ronin RS2), and it is not meant to be mounted on the quick-release plate like some people may believe. If you want to mount horizontally, you MUST remove the vertical wall and mount the camera onto the base plate. That means carrying the Allen key and making sure not to lose the screws. All of this is evident in the description photos, so I won't deduct any stars. It's one of those realizations you get only until trying the product.

I have not connected it yet but all the parts are there and it is a good solid piece. It should work fine.

It does ultimately fit although it took me about an hour to figure it out. There is tape included to make the sides of the mount bulkier to fit the weebill series, and while it does work I don’t love this workaround. The mount also puts the camera too high and I couldn’t get it to balance - ultimately had to flip the lower arm over and undersling the mount to make it balance. Don’t love this either. However it does ultimately fit this camera, enough that I won’t return it so keep that in mind. If you can’t find another mount, you can make this one work for the weebill family

It definitely fits on a Weebill S , but due to it being a raised plate it doesn’t work when paired with a 5d mkiii , the camera hits the gimbal and can’t be balanced properly , so it’s more a Camera compatibility issue than a gimbal compatibility issue .

It doesn't use the lock stoppers of the DJI gimbal like the DJI mount uses. = (Also, I don't like the mounting screws there is no FLAP on the screws to tighten them down,A screwdriver or coin/tool is needed to attach and remove the mount from the camera.

The product description needs to be updated. This does NOT fit the RSC2 model. Sure it can be forced into position, but any product that needs to be forced is not properly designed.

This was a pain to get on my gimbal, luckily it barely fits, but you do need to put a lot of force to get it to slide in far enough back. Hoping it doesn’t damage my gimbal. Besides that, product works fine

One of the answered questions says that this will fit the Ronin S.The plate doesnt fit into the receiver on gimbal. Its as if the tolerances are machined too tight.