Long Life Lamp Company 10W 2ft Industrial LED Batten Tube Light Surface Mount or Hanging IP Rated Triproof Fittng in Cool White T8 Fluorescent Replacement Ceiling Home or Commercial Use [Energy Class A+]

I purchased two of these, one was installed inside my new shed and the other in an under-decking storage area. In both scenarios the lights were a doddle to install and wire. Very happy with the amount of light produced.One thing worth noting, I installed alongside some IP rated switches that had an LED indicator light. I found that after turning off the light switch the light would still flicker every ten seconds or so. This was resolved by disconnecting the indicator leds on the light switches - the tiny trickle of electricity that the LEDs allowed through the circuit was enough to make the light flicker!

Does the job

Very straight forward. Lighter weight than the old fluorescent unit and good brightness

The light from these is very good with instant start up to full brightness. A clip to hold the plastic cover broke off very early in their life (I purchased 2) and I would be hesitant to test out their IP66 rating as I think they are a little flimsy.

These are very good, I used the 20W ones in my garage, now I an putting these 10W ones in my loft (2) and Cupboard (1). They are easy to fit, neat and tidy.

This replaced 4 foot fluorescent tube in lower part of carport. This unit provides ample light with a lot less current. The other will be used at top end of carport, both controlled by daylight/night switch.

This light has been used very little but only half of it is working now (July. Bought in January). Very disappointing as, until now, I'd thought it was fine.

Good fixture, slightly larger wiring terminals would be better but works well and gives good light.