High Density Polyethylene Sheets HDPE Plastic Sheet Board for DIY, Heavy Duty Industry, 1/8" Thick,Size 12" x 12", White Color

I used this to make a replacement depth stop clamp for my 1980s craftsman drill press. The part is no longer available, so it used the original to trace the outline, cut it out and made a new one. It's been working fine for months. This material is a easy to work with and stronger than the original, brittle plastic part.

I used this to take up the play in a Harbor Freight 20 Ton Press I just purchased. It fit in the movable arbor arm to side rails to fill the gap & Is very slick.

I used this product as baking for a mounting plate. It worked well. I like that it came wrapped in plastic to protect its surface.

This piece of HDPE was true to spec, size wise. It had protective plastic on both sides and was not scratched from the factory. Two big pluses. Unfortunately, it had a nice bow in the middle, probably a good 1/2". Not even close to flat. If that is important to you, buy a thicker piece if you can, or find another material. I sort of expected this to be flat but it wasn't. Didn't matter too much for my intended application, thankfully.

Would be five stars if it was flat. Came warped but still worked for my use

Quality seems to be awesome I will be cutting some strips to use it as needed

As described. Easily cut for spacers and patterns with a jig saw.

When thi arrived I knew it wouldn't work for intended project as it was so bent. I figured I would keep it for small stuff however I doubt that was a good decision. The material looked like it had abused plastic film on both sides. Nope! Only one side and both were severely scratched up. I made it worse trying to remove a film that wasn't there.I cut up one for corner braces, ordered another elsewhere. The product is sub standard, and has been abused prior to shipping it to me. Bad!