Rmiott 25.4mm 30mm Rise Riser Bike Handlebars Length 640mm Aluminum Alloy - Fits 25.4mm Stems

Quality is pretty good

Bought an used mountain bike during Covid which was too small ( bikes were hard to find back then) and forced me to ride in a very bent-over position which resulted in a pretty sore neck after riding for a couple hours.After considering a few ways of altering the handlebar position to allow for a more upright riding posture, I settled on these and the difference is night and day. :)The tight bends on the new set made them a bit of a challenge to get through the old stem's one-piece opening, but a bit of persuasion with a pry bar was enough to sneak them in place and the rest was simple.Yes, they are short, (the measurements are in the listing, so check them ahead of time) and yes, space for shifters, brakes and bell is tight, but everything fit and I'm totally pleased with them.They pretty much salvaged my ride. :)

I bought this because I was leaning too far ahead putting too much weight on my arms. My original bars had about a 1/2" rise and these are about 4". It's a night and day difference for me. So much more comfortable riding now that I don't have to lean forward so much. I'm 5'10" and my seat is as low as possible. These bars are aluminum and very light. I hope that won't be an issue down the road, but I don't see why it would be. These are aprox 24" wide, same as my old ones. These bars are marked to make shortening the width easier but I did not need to do that. I am extremely happy with these.

Nice and light.

Fit right. Paint scratched easily but are aluminum bars so should last well.