VVIVID Epoxy High Gloss Black Carbon Vinyl Automotive Wrap Film DIY Interior Easy to Install No Mess (11ft x 5ft)

Looks very realistic. Those are not scratches, it is so glossy that it looks wet and picks up every highlight. It does not stick as well as I hoped in the Texas heat in some of the high contoured areas so I may pull it back off and hit those areas a little extra with the heat gun to really try to glue them down.

It doesn’t have the depth I was hoping for but it’s a decent carbon vinyl print. Relatively easy to work with.

First time using vinyl wrap. Could of done a better job if I would of practiced a little.. stretches nice with a heat gun, but a liike stiff for narrow angles. Making it hard not to bind up and to look nice. User error on my part. As far as the product, top notch and looks cool.

works great thanks

Looked great and installed easy. After a couple of snow boarding runs, it peeled up at the edges, which then lead to it coming completely off. This is the first time I've installed a wrap...so possible that it wasn't perfect. I would definitely cut it back further from the edge to try and avoid the edge peel up. But in general the cold temps and the edge carving of snow boarding likely make it tough for a skin to stay adhered.

It looks great when applied right

This wrap worked out nice and was very forgiving when you needed to remove air bubbles or wrinkles

Was exactly what I needed.

Very good quality thanks vvivid

The product was applied to the flat edge of Auto panel. Adhesion was very weak/poor and has tended to lift.

Remember you have to heat it and apply it on flat surface not textured surface lmao everythings perfect but i tough it was more glossy but looks great tho

Used this for my car mirrors, and as it got wet it looked holographic, and it faded out in no time, probably better for interior as i sealed all the edges when i fitted it but still affected by water...to expensive for the way it failed