Samman Corvette Jack Pucks Aluminum Jack Pad Jacking Puck Adapter Support Compatible with Chevrolet Corvette C5 C6 C7 C8, Leave in Lifting Pads Compatible with Porsche Frame Rail (4-Pack, Black)

Easy to install and worked good.

Very easy to install. Worked perfectly for lifting the car. Helps you identify the lift points.

Very nice craftsmanship on these. fitment is spot on.

Quality product and easy install but these pieces are not .62 (5/8") thick- more like 1/2- but work just fine. I do suggest BLUE loctite (in case you ever need to take them off) and make sure you have your own 5/32" allen wrench because the supplied one is junk and stripped out after tightening four of the bolts.

Purchased these for my C5 Z06 to try out. I have normal hard rummer lifting pads, but was interested in some mountable ones. Already used them with my QuickJack and they were nice and low profile in comparison to my Hard rubber ones and didn't budge. When installing I made sure to put some blue lock tight on the threads to avoid them from backing out. If you want some mountable ones that you can leave on the car, these are worth a look at. Quality hard rubber regular lifting pads cost the same if not more.,One thing to note is that if you are using a floor jack you will want to make sure that is either had a rubber pad on or in the lift cup as these are very low profile and obviously designed for use with a lift or jack with a flat or padded lift. They only stick out from the rockers on my C5 about a 1/4" or so.

Good product, fits, works, correctly sized and well finished with all hardware. Pre-assemble them most of the way leaving about a quarter inch gap, add threadlock, feed them in, twist in place, and finish tightening. They add just enough height to allow a flat surface to clear the body, and make the correct jacking points obvious. Great.The threadlock may not be necessary but the bolts are small, there’s no room in the joint for bolt stretch, and there is no way to add lock washers with the recessed cap screws. So I suggest it if you intend to leave them installed, which is one of the main benefits, then use threadlock.About the only thing I can add is that I’d like the jacking surface to be hatched but it would add a lot of cost to making them and maybe not add much real benefit.All in all very happy with the function and value.

Love my C8 but it certainly has some quirks. No available jacking points without these “pucks”. They come in a bunch of colors but really who cares you can’t see them. Installation was easy.

Very nice parts, look pretty good too. Could be a bit thicker to completely clear the body work but I understand being permanent they cannot hang too low.

All the bolts were missing and all the small backing plates were missing.