Fancasee3.5mm 1/8" to Speaker Wire, 2-Pack 6FT TS Mono 3.5mm Male Jack to Bare Wire Pigtail Connector Adapter Repair Audio Cable for Speaker, Trigger Cable

Perfect replacement speaker cable for my Klipsch 2.1 speaker set. Fit is tight, and the static on my speakers went away

Nice long wire, was used to control amplifier and processor. Did the job.

I’m connecting my analog synthesizer to a voltmeter to measure control voltages, will do the same with my sequencer. Cable works perfectly with a couple of banana plugs on the ends. Length is perfect.This is very small gauge wire, maybe 24 gauge, so be prepared and handle carefully.

I needed replacement speaker cables for a Klipsch ProMedia 2.1 system, which uses the 3.5mm TS connector on the speaker side, and bare wire on the subwoofer side.These are the right format cables for that. You might want to tin the bare wire side so they don't fray over time, but if you're inserting them once and leaving them alone that's not necessary.The price is reasonable for what they are, so no complaints on value.The wires are a pretty small gauge at only 24ga each. They are also not copper (they are silver, not sure what metal that is?). For speakers, I would normally want something copper with a little more conductor, but I didn't notice anything wrong with the sound, so they seem to be enough for the power going out to the Klipsch remotes. They are also side-by-side wires, not shielded, so I wouldn't lay them on top of an electronic component if you don't want to introduce noise.I know these could be used for other purposes besides speaker cables, but that's what I used them for so that's what this review is based on. Overall, just took a star off because of how thin the wires are, but if you don't care about that it would be 5 stars.

Works as intended