SPARC Argon CO2 Flow Meter + Welding Gas Regulator for MIG Welding TIG Welding 0-70CFH CGA580 LIFETIME USA WARRANTY

Ensure do soap test and tape

I was looking for a flow meter for argon gas and found this one on amazon. It was half the price to comparable ones and when i got it was much better quality than expected. Definitely recommend this product

Decent value for a regulator. Really like the ball flowmeter which absolutely lets you know that gas is flowing (My Hobart regulator died after a year with a stuck needle showing gas flow when there wasn't any). My MIG welder worked really well after changing the regulator. I had to modify the outlet to fit my gas hose. I had a 3/16" i.d. gas line that would not fit the abnormally large (0.33" O.D.) barbed fitting. I ended up buying a 3/16" barbed fitting to CGA 032/033 and a 9/16-18 nut for 3/8" tubing to retrofit onto the regulator. Worked well. I see that competing brands (The same regulator body looks similar on many other brands) often have a smaller barbed fitting, but the pressure gauge is nice on the Sparc version.

This was replacement unit for the first flow meter that I received. The first one leaked slightly for no obvious reason. It was used on an old welder that hadn't even gone through its original small roll of wire yet. The tank and valve were brand new and undamaged - when I shut the tank valve off the tank gauge read 2200PSI. I could then watch it slowly drop to '0'. In other words, if I stopped welding without shutting off the tank, in a while the tank would be empty. The replacement flow meter doesn't do that. I called the company and their customer service was 'top shelf'. A very good outfit!

Installed this one on my mig tank and the dual model on my tig tank.

This flow meter was easy to setup, easy to read, and I assume accurate. I like the fact that there are no gauges to read other than the gas left in the tank. I'm older and just learning on my own to weld and easy is good. It took me just a minute or two of practice beads to learn how to adjust the flow. I would recommend this meter for the ease and the price.

This replaced a failed regulator on my mig welder. I wasn’t sure about the needle valve style of flow control. I was used to the handle style. Also I had dial gauges so the new glass scale was new to me.Installation was easy. It went together as it should, seems well made, and functioned properly out of the box.I got used to the flow control right away, and found it much easier to control the gas flow than the old style.

Surprised for made in the USA plastic tube leaning and gage low by 300psi but does hold pressure over night.

Look good not try yet but it’s looking good quality. Thank you

works good for the price

Works good, good price.

Same as description

Awesome packaging!