42 x 18 Hot Water Cylinder Jacket Tank Insulation by Mangers

If you are used to this kind of product you won't be disappointed. It a set of four red bags with wadding sealed inside. There's a grommet towards the top of each bag which allows you to tie them altogether and thin tape to wrap around the cylinder to hold the bags in place. Simple, but does the job.

I purchased this cylinder jacket to improve the foam insulation on my hot water cylinder where some of the foam had to be removed to allow the cylinder to fit in the cupboard. I had no problems fitting the jacket which is in three sections, the cord for the top was fine, and the squared off top of the sections layed down and folded over each other easily,just leaving the supplied tapes to tie around the cylinder to finish. All in all a very good jacket for the money and easy to fit.

I recommend this product. Ours had a very minor manufacturing fault, in that two of the brass rings around the holes near the top of each panel were missing. But threading the cord through the holes in the plastic was straightforward and the material didn't tear: performance unaffected.

Easy to fit, water is staying hot for longer. Good buy

Good quality and certainly does the job but seems bigger than the stated measurements. One day I'll get around to tidying it up a bit. Good value.

Perfect. Didn’t realise how bad my old cover was until I fitted this one. Water stays hot for ages and my tank looks like a Sumo Wrestler now! Only down side is my airing cupboard isn’t quite as hot as before. Easy to fit too, all tucks in nicely. Highly recommend.

Bought this to cover our new hot water tank which just had sprayed on foam. It was a little bit of a faff to fit with the string for the top of the 4 panels (you attach them separately and tie together) being a bit too short to make this easy. If your tank is in a cupboard then you will need long arms to get around the back and also make sure you don't cover the immersion heater. Once on however you can really feel how it retains the heat so hopefully this will reduce our gas bill!

I used this product to lag my water heater. Easy to fit and keeps my tank hot