ACDelco Gold TF289 (25174487) Automatic Transmission Fluid Filter Kit

Good kit for 2008 Chevy Tahoe transmission filter change with gasket and filter. Good price. Easy to install. Recommend this kit for Chevy vehicles. Amazon website matches vehicles pretty good.

Fits 1995 Chevy G20 5.7l 4L60. Direct fit, no issues.

Perfect

Although it comes in basically a white box with a AC Delco sticker, it is exactly as pictured. It is the cork type gasket (although it may be some sort of a cork looking rubber), seal and Filtran filter. I put it in a 98 Chevy S10 with a shallow pan transmission. The old seal is always difficult to get out, but once you find a way this one fits. 98 seems to have been a transition year between shallow and deep pans so make sure you're buying the right one.

Direct fit for my 06.6 4l60E

The media could not be loaded. Don’t trust Amazon when it says it’ll fit your vehicle. I have a 2013 Silverado it’s a four-wheel-drive. They said that this would fit now I’m stuck in my driveway with the pan off. Nothing fits.

Great product

2001 chevy silverado 4.3 V6 shallow pan with 16 holes.this is one job you dread doing! its fairly simple and a little messy. google " 4l60e transmission and filter change" and watch some youtube for tips. here's my shadetree experience,1) latex gloves, lots of cardboard, shop towels, trash bag and oil catch pan.2) socket set, flathead, pry bar, mallet or hammer and block of wood. ramps make it a lot easier!3) i striped my drain plug, its a common problem, so this i what i did. loosen bolts and take out the bolts from 1 rear corner, let drain. when done take all bolts out except 1 middle bolt rear and 1 passenger side front. leave both loose where you can get a 1/4' clear tube in pan and siphon out the remaining oil, go in from the front drivers side. works best when tranny is WARM. takes about 1 hour for ~4.5qts in pan.4) clean inside pan with paint thinner. remove gasket with razor. small brass brush helps get gasket residue off pan.5) put gasket under something heavy and flat couple of days before install. lay gasket on clean rim start all 16 bolts, thread them up at least 1/4". install filter followed by pan. start bolts by hand using extension and had tighten. using 1 hand go in a crisscross pattern and tighten, 1 HAND! DO NOT OVER TIGHTEN, you'll smash the gasket and get leaks.6) follow manual for fluid and capacity for make and model. check after driving for ~30 min, park, leave running and check fluid level. check often for a couple of days on level surface.don't be cheap on this one, i've got 190k on mine, it will be the last filter. perfect fit! i did not replace the filter seal, mine was still in great shape. i refilled 5 qts of valvoline dex/merc in my ole tranny, hell it lasted this long, why not. 07 and up will be dex 6. wally and amazon carry both.