Rounded Holster Claw Kit - for Tuckable & IWB Holsters from Rounded by Concealment Express (Holster Not Included) - Wing, Modwing - for Left or Right Hand - American Made

Well-made and easily adjustable. Perfect fit. Firmly attaches to my belt in an appendix carry position.

Worked great. It looks like I bought my holster like this.

Great claw, rough presentation. All the parts come in a little baggy with no instructions or tools, looks like something you'd get ordering from temu, hard to believe it's from a name brand. Besides that though the claw is perfect, feels high quality and gets the job done. Makes a serious difference.

Helps out with conceal

This is my second claw, and unlike the first one it has enough texture to not slide around. 3 days off initial use and it's right where it's supposed to be. There has been no sliding above or below the belt. Easy install if you have common sense. I would buy this again. But that will depend on if there are any issues with it. I will update if there are any problems.

Great accessory for any holster compatible to minimize printing. Easy to install.

I’ll start out by saying that I’ve got a “We the people” holster…so I wasn’t fully counting on this piece working out, but I knew from the reviews on the one that WTP (we the people) makes that I wasn’t wasting my money on theirs…I thought that the material of construction on this one looked like it was of much higher quality…with all that said I was able to get it to fit with what I would consider minor modifications…first off I removed the retention screw that came with the WTP holster…I used the bottom hole on the claw to go through the existing retention screw hole already on the WTP holster…one of the long screws that came with the claw was the same thread to thread into the existing retention nut that was on the WTP holster…only problem was that it was about a 1/4” too long…so I took a side grinder with a sanding pad and just pushed down on it until I got it to the right length…when you do that you need to make sure that you round off your edges where you’ve flattened the screw…then you just tighten the claw into the existing retention screw hole on your WTP holster…once you’ve got that tight/adjusted to your desired retention level…adjust the claw until it looks square…drill a hole through your holster…I used a 1/4” stainless bolt…stacked washers in the middle where the gap is that your retention screw adjust…then put a lock nut on the other side…and voila…and I’ll also add that this made a huge difference for me with printing…I don’t feel nearly as concerned about someone noticing I’m carrying now and it didn’t effect the comfort level in any way. Great product.

This holster wing initially made a big improvement in comfort and concealment. I carry a Walter PPS M2 with an 8 round magazine and it is almost unnoticeable when appendix-carried with an IWB holster and wing. Unfortunately the material this product is made of began to bend after about 100 hours of carry time. It is still functional, but the amount of give that the wing/arm has defeats the purpose of using a “tall” pad on it. I personally feel like the amount of flexibility present in the wing makes it less effective for concealment. I would be interested to see this product offered in a less pliable material, such as titanium.