Lebra Covercraft LeBra Custom Front End Cover | 551036-01 | Compatible with Select Chevrolet Impala Models, Black

Fits great as advertised. Good quality material. Purchased this because my 2011 Impala's front end is designed in a way that is susceptible to minor nicks on hood damage from small road debris.Two parts to this custom fit bra. Lower part is bigger and covers from below the hood down to beneath the front bumper and around to fender. The lower part is a little more challenging to install but not too difficult if you are patient and follow instructions.The top part is a very easy and fast install. Looks nice. Covers front top of hood where most nicks occur. Both upper and lower parts will need to be removed to wash car. Not advisable to keep on through car wash as water will be forced underneath and may take too long to air out. I will be removing the lower portion and will only re install on very long road trips. The top will stay on as it affords the protection I was seeking. It is easy to remove for washing.You must wax your car before installation for the best finish protection.

Fit 2013 Impala

Who doesn’t love a good bra

Sent the wrong cover...did not install until a couple of months later by them, was to late to realize. My fault, but it was a birthday present. Actually ended up pitching it in the trash since I had no idea what vehicle it went to. The quality and shipping were great, but if it don't fit, it don't fit!

I installed this on a 2007 Chevrolet Impala SS to preclude any more stone chips in my paintwork.My wife says it makes the vehicle look bada$$. I like the look of it, too.I especially like the two-piece design, which ensures no issues with putting the hood up with it installed. No interference with anything under the hood when closed, either.The cut-outs in the vinyl align with the headlamps just fine.I installed it single-handed in less than an hour, but you will need a fair bit of hand and arm strength to do it. And you need to be prepared to scramble around on the ground to fix the clips under the bumper.I have three minor gripes with the 2007-2012 Impala version of the LeBra:-1) The vinyl stretches away from the lines of the bodywork in a couple of places on both sides, which makes it look like it's not a perfect fit. (See photo.)2) Some of the mounting points are only flat "tabs" of stiff material which are designed to slide into crevices in the bodywork, under headlamps, etc. This doesn't create a solid attachment and these tabs can slide out over time and need re-inserting. (Though nothing has worked itself loose during long highway runs.)3) The netting section covers my fog lamps under the bumper. (To the right of the arrow in the pic.) Inevitably, this will impact the brightness of the lamps to some degree and does detract from the aesthetics.Overall I am happy with this item and would buy again.

I love it fit perfect on my car 🙂❤️

The top was super easy, that bottom. I wanna cry! I broke a nail and I just can't seem to put it on. I don't know if it's because my 2011 chevy impala don't have the proper connects on the car for the bra to attach to or what!!!! I need help. I want my car to look different and a lot of people say the bra is old school. I'm like yea yea, it will cover a dent on the front and make my car look brand new without spending hundreds of dollars. Please help me. What's a easy way? Or what do I need to do?

It holds my Chevy Impala breasteses really nice. It lifts and separates.