Wire Twisting Tools, Electrical Wire Stripper and Twister, 4 Square 3 Way/ 5 Way Twister Wire for Power Drill Drivers and stripping wire cable (2, Blue and Orange)

Great gift for my son

I do a lot of prototypes of electronic devices and I like to make the internal wiring neat and orderly, so these devices work perfectly for twisting up the wire pairs. Simple device that is worth the investment. Provides much better results than twisting the wire by hand.

The wires get all mess up. Do not stripe or twist very well. Very poor quality, as well. Not a good tool to waste money.

It's a great concept, and they do work, just it's a little harder for them to get the job done in tight spots. And in electrical work ur always in a tight spot lol but they can definitely be of use for sure to some people, or maybe a little more practice with them and it could end up being an everyday tool to someone. For the price they are made good, and worth it to try out.

These do work to twist wire if you are patient and are careful to run your drill very slowly. The two wire twister is not really ever needed as the wire will also twist two wire. Biggest problem with using them while working on a home wiring project is getting the wires all lined up properly in the device. It takes a lot of practice with a lot of failures which wastes wire. Sadly I went back to the old fashion hand twisting with a pilers as these did not work well in tight spaces and were very slow and inconsistent for twisting.I did not have much luck with them as stripping devices. If give them one start there. Way easier to strip wire with your hand striper prior to twisting with this tool.

I do alot of car stereo and wiring work. Used to use my drill. These work much better and it looks nice when done.

I purchased the orange and blue, 2 piece unit but this pic show what it does the best. It is simple to use once you get the rhythm down. The hardest part is removing the romex outer cover. There is a slick tool for that but it wasn't in my budget. However, this tool was affordable and made beautiful connections on in in line LED string. The lights were low voltage but I had a 14 gauge Romex installed. The only part that was required for me was buying the correct size wire nut. It is important because the perfectly twisted connection is a fire hazard .

I bought these solely for wire twisting. I also knew they would be crap and need additional work to make them usable. After I removed all sharp edges by rounding them with my Dremel they work great. If you don't do that, they will strip loads of insulation off the wire where you don't want it stripped.