New 2pcs Sliver Al Rear Lower Control Arm Upgrade Performance Replacement Racing Kit fit 1994-2001 Acura Integra / 1992-1995 Honda Civic EG

This fit on a 99 Integra hatch. As has been the case with every set of rear LCAs I have installed (twice now on 94-01 Integra hatches, and once on a 91 CRX Si), they are a pain to get the bolts to line up between the chassis, rear wheel hubs and shocks. I don't know if it's a design flaw, or if there's a tool or special method, but it's always a nightmare. Good luck if your bolts are seized/rounded/broken lol.As for it actually doing anything? Probably not, but I thought it did, combined with rear subframe brace, the rear of the car felt less "boat-y" than it did before. Placebo? Who knows. For the price, it's not a bad mod to do in my opinion.

first of all for all the crybabies complaining about bushings not lasting, the Service Manual for the Integra states that the car must be on the ground with load on the suspension BEFORE torquing the bolts to 40FTlbs. they probably torque it while its on a jack or stands or in the air then lower it back onto its wheels end resulting in the bushings being twisted. then over time the suspension travel probably tears them. but these lower control arms look great and feel great. but the holes for the rear sway bar link SHOULD of been threaded M10x1.25. that is OE spec. tried threading the OE bolts in and NO GO. they tapped the holes to M10x1.50. so you will need to take one of your OE bolts to ACE and get them the same length but in M10X1.50, confirmed and provided pictures of the OE LCA and a M10x1.25 tap. Installed on a 94 Integra Sedan. may post a update later

Brotatochips listen up..these are by far the best lower control arms for the Integra you can buy... I can’t speak on the EK or eg Open the Acura Integra guy it is by far the best got about 8000 miles on them right now and I’ve had them for three months they are amazing

It was difficult to put on since I had snapped 2 bolts prior to the purchase on the old control arms. Had to drill through them and it took forever. This doesn’t feel bad once on and looks good but I’ll eventually get Truharts later

I am very surprised at the quality of this product for the amount of money it was. I usually would spend a couple hounded on this type of control arm. I honestly purchased so I could swap out ones I had to sell vehicle. I’ll definitely recommend and possibly use these again in the future.

Perfect replacement 92 civic hatchback

91 crx perfect fit. Arm wants to twist slightly I recoment getting outer bolts in first and work your way out

They fit like they are supose to i like the look of the aluminium. They are rubber bushings like the stock ones not poly but they work good for what i need them for.

they look and fit nicely but the the bolt hole for the sway bar end links are the wrong thread. tapped to the wrong thread spacing. dont buy these if you expect a problem free install. i had to drill out the hole and get a longer bolt then put a nylock bolt on the end. its not exactly right but for the price its good enough.