AquaClear70 Power Filter, Fish Tank Filter for 40- to 70-Gallon Aquariums, Black

Good filter and does what it is intended to do. I always use a larger filter than what is recommended for the size of my tank. As a starter tank for my daughter we got her a 20 gal tank package that came with a cartridge type HOB filter. The cartridge type filter becomes overwhelmed very quickly and will not last the recommended 30 days. After about two weeks with an under populated tank we noticed the water clarity going down. After a few hours of running this filter before a water change the water quality improved significantly. Only complaint with this filer is that it came very scuffed up on the housing of the filter and extremely dirty. The lid is warped and doesn't fit right otherwise it would be a 4 star. Filter is functional and fairly quiet and has a water flow adjustment. It does not come with the water intake pre-filter as the images suggest. I did not find the motor to be noisy as other posts suggested or at least not noisy enough to complain about and quieter than the last filter which we purchased from Petsmart.UPDATE!!!! - 6/14/2025 - as mentioned above the lid on my product was warped and does not fit right. After about 1 week of running this AC70 filter, water was pooling around the tank. The filter was leaking water where the motor connects to the housing. I tried to tighten it and reseat the motor, no luck and the leak continues. In the pictures you can see where the minerals are drying where the water drips from. Amazon is replacing this product so I hope the next product functions correctly. By the way the majority of the images for this product are of the Fluval AC70 and not of this product which is made by Fluval but of cheaper quality. If the new one has problems Ill return it as well and spend more for the actual Fluval.UPDATE PART 2 -6/17/2025 - New (replacement) product arrived from Amazon and it was in much better condition than the previous product. It was not all dirty and the filter housing was glossy and not scratched like it had been used. I promptly changed out the old filter for the new one and overnight there does not appear to be any leaking. In the removeable motor housing there is an "O" ring that helps create a water tight seal. It is possible that on the old filter that it too could have been damaged or old. Not sure if this was a quality control issue or if these were from different manufacturing sites because even the durability of the plastic housing and lid seemed better. Initially I gave this product 3 stars due to the damage to a new product. Since the product is now functional and looks like a new product and does exactly what it is supposed to do I upped to 5 stars. On a side note I would highly recommend the the intake filter that does not come with this product but is a very cheap item. I thought it was just for larger particulate matter but when I was replacing the filter I removed the intake filter to use it again. I brushed off the larger visible particles and decided to give it a quick rinse. When I rinsed it I notice that it collected a lot of fine particulate matter and had to rinse it about 3-4 times before it ran clean. Also after about a week of the old filter running the white foam filter showed almost not dirt or discoloration. When I rinsed that filter it showed no dirty run off. Conclusion - intake pre-filter is a good investment!

UPDATE: 10/15/14I have just purchased my first Aquaclear HOB filter in more than three years. I presently own an AC 110, AC 70, AC 50 and 4 AC 20s. These are great filters because of their clever design and tremendous flexibility.I am presently using a pair of Aquaclear 20 filters for polishing the water in my planted aquaria. The filters are equipped with a mechanical filter pad and a micron filter pad, the later of which is used to remove the finer particles from the water column in these tanks.I like using the AC 20s as part time maintenance filters because they are small, very easy to clean, and do an excellent job of filtering my planted aquaria.I use an AC 50 in combination with an Eheim 2211 and Cobalt Aquatics DUO 500 in a Mr. Aqua 17.1 gallon aquarium. The DUO 500 is an internal filter, however, its primary function is as an LED UV clarifier.I downsized some of my tanks, so the AC 110 and AC 70 are no longer in use. HoweverI keep them around as spares, since you never know when you will need an extra filter.One of the best aspects of the Aquaclear line of HOB filters is that the motors in the AC 20, AC 30, AC 50 and AC 70 are the same. The only difference is that the impeller fan is slightly larger on each subsequent model of these filters.The fan can be easily removed, and either a larger or smaller fan (depending on the AC HOB filter that you are using) can be added to meet the demands of the particular aquarium you are using.This is why AC filters are so popular; their tremendous flexibility.For example, suppose that you have a 20 gallon aquarium and are using an AC 20 that doesn't quite get the job done. You can purchase an impeller assembly for an AC 50and then use it to replace the AC 20 impeller fan, which will give you twice the circulation that you had with the AC 20 impeller fan.As another illustration using the inverse of this situation, suppose you are using an AC 70 in a 30 gallon aquarium and find that even on its lowest setting it isstill causing too much turbulence for your fishes.You can replace the AC 70 impeller fan with an AC 50 impeller fan. This will still give you the filtering capacity of the AC 70, however, without the turbulence that the AC 70 impeller caused.Earlier...My recent purchase of an Aquaclear 70 HOB (hang on back of tank filter) filter ill make this my 8Th Aquaclear. I have five Aquaclear 20's - three on guppy tanks, and two kept as spares in the event of a breakdown. However, in over a year of constant service, I have yet to have an Aquaclear HOB filter's electric motor burn out.Moreover, one must take care to turn these filters off when you are using a sand substrate which is being stirred up in the tank, since the sand can get into the motor and cause it to run roughly, or seize up.Even if this happens, all it usually takes to get these motors running again is to remove them from the filter housing, remove the impeller from the housing on the motor and clean the unit with water and a q-tip.Once you have done so, the motor will usually begin to run properly again.However, once sand gets sucked into these motors, it mars the finish of the impeller, which can cause it to make noise.I also own an Aquaclear 50 which I now keep on my 10 gallon tank, and an Aquaclear 110 which I use to filter a heavily planted 20 long tank with about 16 fish.So the extra filtering capability of the Aquaclear 110 is nice to have.As for the Aquaclear 70, this will be replacing the Aquaclear 50 which I used to filter my 37 gallon tank, and have now moved to my 10 gallon.The Aquaclear 70 will be used in conjunction with a Fluval 305 canister filter for redundant filtration.The Fluval 305, like the Aquaclear, is another Hagen product. It seems like virtually every product that is sold for the aquarist is manufactured by a subsidiary of Hagen's.The 305 is also a very cleverly designed filter, which works quite well, and is very easy to maintain, thanks to Fluval's patented Aquastop feature; the Aquastop fitting allows you to disconnect the 305 from its tubing without losing suction, so that you don't have to reprime the unit once you've dumped the water from its container during a filter cleaning.All you do is reconnect the Aquastop fitting to the top of the 305's canister, and then open the flow valve until the 305 fills with water.You must open the valve partially to avoid creating a tremendous amount of turbulance in your aquarium, since if you open it all the way while filling the 305, the air bubbles will race out of the 305's exhaust tube disturbing your fish.As for the controvery between which canister is best, many people who consider the purchase of a Fluval also consider buying an Eheim, and there are those who own both. The Eheim - Fluval debate reminds this author of the Chevy-Ford controversy, regarding the merits of each.Moreover, I have owned both and find that Fluval and Eheim both make excellent canister filters. However, the Fluval's internal setup is much easier to use, given the trays Fluval includes to add filter media to, while the Eheim Classic series (I'm not certain if the other Eheim filters are the same way) just stack the media atop one another, making for a more complex arrangement, since the Eheim's filter media is in not in a tray.Both filters are well made and reliable. However, one must take care to re-lubricate the Fluval's o-ring after each cleaning to ensure that it does not dry out, since this will prevent the unit from leaking onto your floor. And careful removal of the impeller housing will ensure that the impeller that does not get damaged.After more than a year with the Aquaclear series of filters, as well as the several months with a Fluval 305, I must say that I am very pleased with these units. They are cleverly designed, well constructed, and should last for years provided that they are properly maintained.Jim

It's human nature to never write positive reviews because we are more prone to complain rather than praise.BUTI'm very pleased with this filter so far. It's so quiet that I have to keep checking if it's still on and there are no water spillage issues. The water cascades gently and at the right angle unlike some of the other HOBs that tend to disturb the substrate underneath their flow. I almost feel like getting rid of all my other filters and replacing them with this kind! One of the reasons for it is the convenience in monitoring the status of the gunk build up. Everything is clearly visible as opposed to the canister filters that keep you guessing until they suddenly get clogged when you're on vacation. For even less maintenance you can also use a sponge pre-filter on the intake nozzle that can be easily cleaned on a regular basis.