Leite 10pcs LC UPC Fiber Optic Quick Connector wiht Matched Tools Single Mode Mechanical Fast Connectors Adapter for FTTH CATV Network Instrument for 2x3mm Butterfly Cable

The instructions were a bit unclear, but if you examine the accompanying pictures closely and don't skip any steps you'll do well. Bring a bright light and reading glasses.

I recently needed to terminate a 6 fiber orange Multi-Mode inside building and I ordered a kit with a cleaver that no matter what I did to adjust the cleave it would not cut the fiber. I ordered this kit due to the video and it works as shown. The little cheap cleaver works perfectly and all six of fiber LC connections are working. I used the Fiber Light while inserting the fiber to the LC connector which helps.

I was about to come on here and leave a bad review + request a refund BUT on my 7th try, I was able to successfully get a connection. I had to strip my fiber back further than in the video or the pictures show or even the guide on the tool. I would say these are very fragile and should really only be used in a pinch. I had a cable to an outbuilding that made a lot more sense to repair using these than try to replace it.

Conectores muy prácticos y de fácil montaje

connectors don't fit over my fiber jacket.. cleaver works maybe half the time.. tossed it in the trash and purchased better tools. couldn't even get a link light using these tools. be better if they just dropped the price a little and left out the cheap tools they include.

They work really good once you figure out how to finesse them together! The light meters out great!

These don’t work, the tools provided are terrible, the cutter does cut, stripping tool is dull and has uneven marks on the blade. The main issue is the cutter doesn’t cut at all. The instructions are written poorly and don’t make clear or concise sense. Seriously, just don’t buy these, you’ll end up frustrated and back to square one only with less optical cable to attach a connector to.

I didn't have any issue with getting it to work, I did see some insertion loss, but it was less than 1 dbm and not a problem. I used the cleaver it came with, and my own strippers.The only downside, is that it only secures the 900um tight buffer of the fiber, not the 2 or 3mm outer jacket. It would have been a relatively simple matter to design this such that the outer jacket is captured and cinched down.The end result is rather delicate and should be contained in an enclosure, and not directly use it in a patch panel or the back of a server. Certainly one doesn't have to use an enclosure, but it's risky as exposed 900um buffer is usually protected against physical bumping.