M5 Neoprene Well Nut M5 with 20mm Stainless Steel Pozi Screw (Pack 6) (E)

Good quality, good for kayak handles

These worked exactly as expected! I have a slightly lifted 4x4 pickup and ever since one of my high school students received a ticket for not having mudflaps I fear that I'm on borrowed time, as I do not have mudflaps on my own pickup. My truck has oversized wheels and tires and I have fender flares that cover the top, but they don't protect anyone behind me from small stones, snow, and water spray. I know that I should have considered all this four years ago when I installed the wheels and tires. OK, back to the mudflaps and these well nuts. My flares are anchored directly to my truck with four to five screws each, but when I move the mudflaps outward to cover the full width of the tire there isn't any metal to fasten to. My solution, questionable as it may be, is to add one more screw mounting the flare to the truck and getting one, or two screws through the flap, flare and into the steel fender. Then I use two, or three of these well nuts to anchor the flap to the flare. I'm not sure how it'll hold up to Utah snow yet in forward, or reverse, but once I tightened up the four mudflap I stood up slapped the bedside of my truck and loudly proclaimed "well that ain't going anywhere".So far these well nuts have exceeded my expectations and were delivered quickly to my small western rural town. #GBR

Good anchors. Used them in a boat and have held up for a few years now. Would buy again

I purchased a set of these to replace some broken rivets on my kayak. Opened the package and saw the instructions, and it said to drill a 10mm hole. When I measured the size of the rubber, it was closer to 9.2-9.4mm in diameter, so did a test drill with a 3/8" (9.52mm) drill bit in another material for testing and it held well. Installed it in my kayak with the 3/8" hole and it works well, probably better than it would with a 10mm hole. The outside of the well nut is not particularly thick so it may difficult to remove it because it will spinning in place.

They were exactly what I needed for a particular project. So glad you had them.

These are being used on an atv where the originals had degraded. Fit the bill, way better price than the oem too.

I needed to mount a small plastic box to an interior plastic panel of my Subaru. With these fit the bill perfectly. All I had to do was drill two 10mm holes in the panel, insert the plugs and then mount the box. Easy-peasy and a secure mounting.

Exactly what I needed.