NABOWANSolid Rubber Sheets,Strips,Rolls 1/16" (.062") Thick x 12" Wide x 120" Long, Thin Neoprene Rubber, Perfect for DIY Gasket Material, Sealing, Liner, Shield, Padding, Mat

The cage for a generator on rear of RV needed a rubber trim to reduce noise and plastic to metal rubbing. This rubber is very tough and has just the right amount of elasticity. Easy to cut but does not seem to scuff or break down from rubbing. Highly recommend!

To all the people complaining that this will not lay flat there is a very simple method to make it lay flat. Simply roll it back up in the opposite direction it came rolled in until the center bit is resting well against the inside of the roll. Then unroll it and it should basically be flat, or flat enough to finish making completely flat.The thickness and dimensions are spot on and this is HEAVY rubber. Perfectly suited for what I bought it for, which is gluing to a thin metal plate to dampen vibrations/noise.There is quite a bit of rubber smell but I can only smell it up close, it doesn't fill the room or anything. I think the smell should go away eventually once it off gasses more.Assuming it doesn't break apart over time I would probably buy this again if I needed more.

As advertised nice product. Very solid rubber not flimsy. Perfect as a quasi mud flap.

Product is as described and once rolled out it remains flat which is a plus for me

Used this to create a better splash guard for my rear wheel well. I used a good exterior construction flexible sealant and self taping screws to hold it in place. Worked great the screw heads did not break through the material and it did the trick. Only enough to do one side though so recommend buying 2 just Incase.

Good quality flexible rubber

This product is good

Using this to help keep water out of my truck bed. Noticed some cracking in the material already. Didn't expect that to happen in 6 months or so. A little disappointed.

Used it on my 60’s Oldsmobile for the rubber inner fender liners above the control arm. Worked great, nice quality, but a little expensive.Should be 6 feet for that price.

bueno

Used it to cover a PVC shed roof at the peak where the panel on one side came out from the groove of the peak which was easier than disassembling to try to fix it. Flexible and easy to trim yet feeling fairly tough, I was able to glue it to the PVC peak to cover the gap to stop the leaks. Time will tell as to how well it withstands the elements but it survived one fall wind/rain storm and being out in the sun on the hot tub cover for a couple of months before that, while I got around to using it. A little pricey, in my view, but it works well for my purposes.