Fender Flares Edge Trim for Car and Truck Wheel Wells, Rubber Seal/Gasket for Fender Flares Universal, Bonds w/ 3M Automotive-Grade Adhesive Tape, T-Style, 30’ Length

Quality is average, i dont think it will last long

I see some reviews stating that the adhesive isn’t good or it sticks to itself and hard to peel of if it gets stuck to itself or it’s not self explanatory. There’s enough for all 4 fenders and there will be extra for 2 fenders just in case. 1) just make sure the surface of adhesion is clean and dry 2) as you are attaching the beginning, go slow, put pressure so it sticks well, don’t try to stretch it to save extra because at the end you’ll have places where it’ll come right off, as you move along you will slowly peel of the adhesion sticker. 3) after installation if there’s small wavey areas just run your finger through the whole strip and it will flatten itself out and then cut off the excess. 4) you gotta let it settle overnight and not let it get wet for maximum adhesion.

Super

Love that it has double sided tape to make it super easy to apply, makes the finished product look professional

They did work on our fender flares but it was tricky to keep them in place during the install. Especially around any curves, the sharper the curve the harder it was. You need to clip the back with sissors just like if you are sewing material around a curve.

Le rendu est sympa, par contre je ne pense pas que ça durera dans le temps, ça ne collait pas très bien.