3-3/8" (85mm)-30T, Metal Working Circular Saw Blade, Arbor 15mm with 10mm Wahser, Use on All Brand 15mm Arbor Cordless Saw, Metal, Steel Iron Bar, Sheet, Angle Cutting

Buen corte,en las tuberias de emt

At first this thing cut like warm knife through warm butter. However within about thirty seconds the honey moon was over. It started slipping and balling down the motor to where it wouldn't cut anything. I've never had an issue with the saw until using this blade. My 2 minute job turned into 15 minutes of pure pain in the rear. I ended up using another cutting blade with much better results.

Bought it to cut tin for my pole barn. Used it in my Ryobi plunge saw. Cut the tin with ease .

This blade came in a box to protect it from getting bent. That was very nice and sharp worked beautifully.

The LSHUZIYU 3-3/8" (85mm)-30T, Metal Working Circular Saw Blade is advertised "Use on All Brand", but as two of my pictures show, the outside diameter of the blade exceeds the capabilities of my saw. When I noticed the problem I measured the diameter of the blades that came with my saw (3"). Then I measured the distance from the center of the spindle to the furthest point inside the blade cover and found I needed a blade no larger than 83mm/ 3.25" (almost an eighth of an inch smaller in diameter than what I received, 85mm/ 3.35"). I didn't see the blade diameter specification in the saw's box when I ordered the blade (I eventually located that information on a side-panel). So, shame on me for thinking "small" circular blades are of a "universal" dimension (except for the center hole, of course) when I read "Use on All Brand" in the advertisement. I really did "assume".....However, I *WILL* commend the company on it's EXCELLENT packaging. It's easy to open - but almost impossible for that to happen accidentally. It also protects the product from damage in normal - and maybe even more abusive than normal - shipping. Once the box is opened there are three tabs that hold the blade in place, used to prevent the blade from sliding around inside the box. After bending the cardboard tabs out of the way, then I could lift the bag which contained the blade and the sizing spacer-washer ("wahser" as used in the informational paragraphs describing the blade) which is used to accommodate various motor spindle diameters (which too aren't "universal", apparently because my saw uses 7/16ths of an inch, not 5/8" or 3/8" - the sizes of the spacer-washer). The edges of the blade are further protected with a vinyl sleeve that once removed, exposes the blade's "teeth" - which are VERY sharp.This product appears to be made with attention to detail, seems to be of high quality and packaged well. I am disappointed it didn't fit my saw, and disappointed again, that I couldn't present its use in a video.

Just received the blade and they look very well made have not tried it but will update review when I do

This item is small. Yes, the description says "3 3/8", which is accurate, but I guess I didn't realize just how small that would be: it's about the size of the palm of my hand (I'm about 5'8" and my hands are neither huge nor tiny). It actually fits fine on my cordless Ryobi circular saw: you can still lower the blade enough to clear the base and take a cut.I plan to use this to simply score metal for bending rather than do any heavy duty cutting; I have not yet had a chance to try this. The brazing on the teeth looks good so I'm not anticipating any problems unless it's that my cordless doesn't have the oompf to cut, but that would likely be more on the saw than the bladeWill report back if the blade doesn't hold up to use, but certainly looks reasonable.

Nice little blade that will rip through what you need it to. You will have to do a little touch up afterwards but that should be expected. Have used it several times and have not seen a change in performance yet.