4 Interchangable Tips: KNIFE TIP -Cutting and removing sections including the removal of supports, brims, and rafts from your 3D print. NEEDLE TIP - Great for clearing small holes and features or for detailed layer refinements in hard to reach places. POINT TIP - General purpose tip for larger internal features and holes. Can even be used for making holes after printing. SCOOP TIP - Prefect to remove stringing and imperfections from inside holes or recesses. Can also be used to blend surfaces where blobs have appeared
D**H
the tips all work fine but some take a little getting used to
works well, only 1 temp which means it can burn the hell out of PLA but also means it cuts through quickly. Couldn't get it to work with a battery pack so using it in the garden was a no go (melting plastic gives off fumes)build quality is so so, the simple body can feel a little cheap but it is strong and works really well, the tips all work fine but some take a little getting used to. this might be a great tool for ABS but i haven't done an ABS print yet.All in all this is a really good product but unless your using a lot of support material and your slicer is sticking it to the model too hard then this isnt a 'must have' but still really good to have incase.
D**V
Had great hope for product
Had great hope for product, but its flimsy and doesn't get hot enough, may be useful for some minor work and has great potential but not for me
H**S
Five Stars
all good
S**S
Didn’t work for long
Lasted a couple of weeks then just stopped working.Loved the idea but not robust enough.
A**R
Its ok
Its ok, its effectively a low powered soldering iron with different ends.... It does the job, but its difficult to tell where the support ends & the finished part begins.
Trustpilot
1 day ago
2 weeks ago
