Seeutek Manual Tile Cutter, 14 inch Professional Porcelain Ceramic Tile Cutter, Double Rails Design Tile Cutter Tool, with Tungsten Carbide Cutting Wheel

I got this tile cutter for my DIY backsplash project. I'm a 71 yr old woman. The 1st tile broke apart in many pieces. I tried again with lighter but firm repeated pressure. I ran the cutting wheel over the tile several times and was all set to give up when suddenly, the tile broke perfectly. 2" on each side of the 4" by 6" stone tile. I also had to cut a 3/4" length and that went perfectly too. I'm happy. I was dreading trips to the hardware store to get tiles cut. Not now.

So this didn't work for my project so I want to return it. Sure, no problem. They give me a shipping label addressed to Shanghai and I have to pay for the shipping. What a scam.

Works very well.

It technically works but go ahead and rent a tile saw from Home Depot or Lowes. While this will cut tile, it will also break a few in the process. It also cannot cut close to the edge. So if you need to cut an inch or two off of a 12 inch tile, it won't work. For $20 to $30, you can rent a saw at Home Depot and Lowes that will work much better, give you more accurate cuts, waste less tiles, etc. I wish I had looked into renting one beforehand, but I just assumed they would be expensive to rent. Instead, I had to rent one anyways because this cutter couldn't cut a few of my tiles because the cut was too close to the edge of the tile and there isn't enough leverage to get a clean break. Again, this works, but it would be better to just go ahead and rent one for the project.

The fact that I got a smooth, straight cut on my first try is still blowing my mind. I’ve never used one of these cutters before so I’m kinda impressed. For the price I’d say it’s worth it. But I did try to cut a little tile and it was a no go. The tile was too small to sit on the middle bend. I would say the tile needs to be at least 2-3 inches wide to get a nice cut but I could be wrong. I barely became a tile cutting master with this tool yesterday.

Bought this from Amazon resale. They said it looked and functioned like new but if that is the case, then this saw cannot cut without chipping the tile. I looked up on line causes and they were worn out tile blade cutter which means this would be a used product.However, it could also mean be Seeutek does not make a good cutting blade.

Cuts smooth and breaks even

It does not work well on a standard 12x12 tile. It was more of a headache and broke the tile into pieces. No smooth cut done. Waste of money.