ANYCUBIC Upgraded Standard 3D Printer Resin, Sla 405Nm Fast Uv Curing Resin, High Precision Fast Photopolymer for 3D Printing Lcd/Dlp/Sla with 8K Capacity (Black, 1000G)

Using the same files that print perfectly with ABS+, this standard resin produces prints with severe warping, curling from poor adhesion, and shrinkage. It is useless even for the prototypes I'm using this for, and would get superior results on my filament printer. Globs of errant half cured resin form all over my print, in many cases reducing the effectiveness of the supports. I had to redesign a few prints for better drainage specifically for this resin and I still got the same slop. It smells terrible, and the black comes out with a dull look. Even with new clean 99% isopropyl and long drying times, this resin is still prone to extremely spotty finishes... honestly if it were any worse and it would actually have a bit of luster. Prints with this come off the build plate extremely soft even after doubling my normal layer exposure time.... so no, not fast curing. Not high precision. If it's upgraded, I'd hate to see the original. It's almost as if this resin was cut with a filler liquid... like water. I have the clear as well, but it doesn't have the same warping or puddling issues the black has, even with the same settings. It does, however, turn completely yellow in anything longer than a 1 minute cure. Even if you sacrifice strength for aesthetics and under cure the print, unless you're making something for a darkroom it will yellow eventually. I didn't save $1 or $2 with this standard resin, I wasted $15.

Exactly as ordered works great for my Photon Mono M7 Max will buy again

Print quality is as always great from anycubic resin. As long as it’s flat, i have no need to put supports on the bottom. Not brittle at all and deep black color is just *chefs kiss*.

Prints well in my Saturn.

Works as expected and produces great results.