ClicSeal Laminate Floor Joint Sealer

This was extremely easy to apply and it's a must if you want to ensure you're giving your floor the max lifespan. It takes 10 seconds extra per plank so not too time consuming either. I'll give a few tips though that we're not in the manual:1. Make sure when you're installing the plank you lift and drop it a few times pressing it firmly to the previous row. I shake it lightly until I see the stuff showing through the joining edge on the surface. This gave me comfort everything inside the join is well sealed and covered with the stuff. Very easy to clean afterwards.2. Actual consumption is much higher than the 10sqm stated on the box. Impossible to cover 10sqm unles your planks are a square meter each. I used standard sized planks from B&Q 16cm wide and I used 12 tubes for 40sqm of floor l, giving less than 4sqm per tube.

This goes on well from the tube and helps to lubricate the joint making it easier to slot the flooring together. It stays workable long enough to reposition a board if necessary. Time will tell if it prevents spills seeping between the joints.My only criticism is that I needed two and a half tubes to do a room 3m by 2.7m which is about twice as much as they suggest hence 4 stars.

Used it on my laminate floor in my kitchen so that if there's ever a spillage It should be ok lol

In any area where water might be present, or even where you want the ability to mop a floor without concern, be sure to seal your edges. This product is easy to apply and easy to clean-up. I have no fear getting water on my laminate having used this! Pic is indeed laminate - double length so it is offset, but still looks like tiles!

I would definitely recommend. You only need a small amount drawn along the line on the laminate. Goes quite far!

Yeah, this stuff is ok - I mean it works and is easy to use etc. But genuinely, it goes nowhere near the m2 suggested by the manufacturer. Ive laid about 12m2 so far and used about 5 tubes (and didn't use it on every joint, just the lower half which would be likely to come into contact with water).

Easy to use won’t really know if it’s worked for some time but happy so far

Before committing to buying many tubes for a 50m2 floor I decided to do a test. I had some samples of the laminate floor I am about to install. I sealed 2 pieces together, and another 2 without the sealant. I left a wet cloth over the joint on both test pieces over night. In the morning the piece with the sealant had some swelling and the piece without the sealant had no swelling. Glad I didn’t waste my time or money messing around with this stuff