Supplying Demand 00436440 00674704 Clothes Washer Drain Pump Motor and Housing Replacement Grey

Easy to use and install. Good quality pump. Durable, I replaced this over a year ago and have not have the problem with it since. Great value for its money. Great performance very little noise.I worked for appliance repair guy for a while. To me this is the same quality as ome at a much more affordable price. Completely satisfied with his purchase and would consider it again if I ever needed one

Bought it for my Siemens washer.Overall its Perfect pump. Same or even better quality than OEM. Better design because it has a drain hose.Works great!Install is little challenge, because I installed it through the little round window on the front. May be from the back would be easier I don’t know. The electrical plug is upside down compare to OEM, so i had to cut the mounting zip ties on the bottom, release the wire harness to make more slack. Other than that it’s easy to install. Ran about 100 loads -no problem.

This pump fit in our washing machine perfectly and has been working well.

This solved my Bosch washer code E13 that is failure to drain. It was a major job to install with two problem areas. The gray drain hose that must be inserted in the top of the pump was incredibly hard to get into the opening until the two tabs on the side snapped into the slots. The second problem area was the electrical plug into the back of the pump motor. The original was set for a side insertion with keyed tabs. This unit was oriented upside down from that so that the plug was a real pain to get connected plus the wires were almost too short as a result. There are several good videos on YouTube about how to do this but they make it look too easy compared to the actual job but I hung in there and am pleased the washer is working great.

New pump was easy to install; did not have to modify pump fittings or attaching components.Working perfectly!

This is exactly what I needed for my washer fits exactly like the old one and even has a hose for cleaning the trap.

Great pump for a great price. I found it easy to replace with the following learned items:1. Tools needed are pliers, T20 torx, 13 mm socket with universal, and 13 mm wrench (ratcheting wrench works well).2. If your machine is old, replace the 2 stabilizing shocks at the same time you have the back open. My machine spins SO MUCH quieter. It is advisable to remove the shock on the pump side anyway to get the pump and discharge hose out the back (see #3).3. Remove the discharge hose as an integral part of the pump and then swap it out onto the new pump outside the machine to make sure the tabs on the hose lock into the new pump. Reinstall as an integral unit and re route the hose back up to the upper back panel on the machine. I disconnected the hose from the back of the machine and then pryed the two tabs to pop "in" the white hose connection that penetrates the upper panel. This leaves one connection un tampered with.4. The hardest part of this job is getting the sump hose reconnected to the new pump as the spring style hose clamp is precarious to reinstall with pliers inside the machine.

It fit properly and has been working for about 11 months I don't hear any unusual noise