Santa Barbara SurfingSBS - 8 inch Longboard & SUP Single Fin - 8" Center Fin for Surfboard & Paddleboard

Works great, easy to install and durable

Fits like a glove, shipped overnight. Ready to try out this board I picked up! Totally happy with the fin. Feels relatively stiff like a normal longboard fin (not cheap and flexy) I like the no-tool fastener. Prevents slipping and damaging board with screwdriver. Good deal.

Fits snug in the fin box. Surprised its a nice sturdy fin for such a low cost. I'm using it in a thruster setup with my board. Should give me the stability I need charging the big waves this winter.

It’s a little difficult to get in and out but I’m so glad there was an option to replace my type of fin.

The perception fin had been out of stock. It's a 10" fin and I couldn't get other 10 inch fins installed. I purchased this 8" because the base had the right measurements.I loosened one end of the fin box (not sure if this is the right term) on the perception hi life, installed the washer over the screw hole in my kayak. I tightened the box down and it held the washer in place. I can put in the fin, attach the screw to the washer and easily uninstall when I'm done. I have only used a couple times, so hope the washer stays in place. You could always remove it each time as intended.Overall, very happy with my purchase since I finally have a fin on my kayak sup again!

Was concerned if it would work with my sup but it did. Hopefully the fastener doesn’t come undone while using it.

This replacement was just perfect for our Boda board. It installed very easily. The support was great although we did not need to watch the video as it was so easy to do ourselves.

The fit size was the closest to that I needed. With sanding at the base, the fin works perfectly with smooth & consistent glide. Thank you